When the cutting machine fails during the operation, the maintenance of the machine itself is a very cumbersome thing, but we must pay more attention to the maintenance process, and we cannot ignore many problems because of the cumbersomeness. I would like to share with you a few things about the maintenance of the cutting machine:
1. When the machine stops working for more than 24 hours, relax the fixed mode of the handwheel to avoid damage to other parts.
Second, to maintain sufficient space around the perimeter to provide conditions for the mechanical placement, provide sufficient space for the maintenance of the machine to check
3. If you hear an abnormal sound when you turn on the power, you need to stop the power detection immediately.
4. Please keep in touch with the professional teachers of the company and reflect the specific situation of the cutting machine to the technical staff of the company.
5. In order to avoid the risk of electric shock to the cutting machine, the grounding terminal must be reliably grounded during use. Please note that the hand needs to be kept dry and requires relevant professionals to operate.
6. Before pressing the machine, the pressure plate should completely cover the die. It is forbidden for the staff to approach the machine traverse pressure domain. Please turn off the motor when leaving the machine.
7. The hydraulic oil of the fuel tank should be replaced after about one quarter of use. In particular, the new oil for the first time needs to be highly valued. After the new machine is installed or replaced for about 1 month, it is necessary to clean the oil net. Also, the fuel tank must be thoroughly cleaned when replacing the hydraulic fluid.
8. When the machine starts working, the oil problem must be controlled within a certain range and then manipulated. If the temperature of the oil is too low, the oil pump needs to be operated for a certain period of time, and the oil temperature is detected to reach 10 ° C (50 ° F). When the oil pump can perform its performance.
Nine, do not loosen any of the terminal nuts, otherwise the motor and electrical wiring may be in poor contact, but the phase loss operation may result in burning and material damage.